How to Get Water Out of a Charging Port? 5 Tried and Trusted Methods

How to Get Water Out of a Charging Port

If water has entered the charging port of your device, it’s important to take immediate action to prevent any damage to the device. Here’s how you can get the water out of the charging port:

  1. Turn off your device: To prevent any electrical short circuits, make sure to turn off your device before attempting to remove the water.
  2. Remove any visible water: Gently shake the device to remove any visible water droplets from the charging port.
  3. Use a dry cloth: Gently wipe the charging port with a dry cloth to remove any remaining water. Make sure not to push the cloth too deep into the port, as this may push the water further inside.
  4. Use a vacuum cleaner: Place the nozzle of a vacuum cleaner over the charging port and turn it on. The suction power of the vacuum cleaner can help remove the water from the port.
  5. Use a hairdryer: Use a hairdryer on low heat to blow air into the charging port. Make sure not to hold the hairdryer too close to the port, as high heat can cause damage to the device.
  6. Leave it to dry: After you have removed as much water as possible, leave the device to air dry for a few hours. Do not plug in the charger or turn on the device until it is completely dry.

If you are unable to remove the water or your device is not working properly after getting wet, it’s recommended to take it to a professional repair service.

Related: Liquid Has Been Detected in the Lightning Connector >> Here Is What To Do.

How do you Get Water Out of the Charging Port with Rice?     

Unintentionally submerging your phone in a liquid will bring water into your charging port. 

 Hence, getting moisture out of your phone charger port is vital. Here are the DIY steps to follow.

  •  Place it in a jar of instant rice for 24 hours or more, depending on how wet your phone is.
  •   The rice will suck in the moisture leaving your phone charge port dry.
  •   Check that you don’t leave any rice particles inside the port.

How to Dry Out a Charging Port using a Towel?

You are likely to experience your phone and water coming into contact. Then, you will need to dry it quickly. Here are quick steps to drying off your phone charging port:

  • Wrap your phone in a towel and thoroughly towel it dry.
  • Turn your phone off to avoid interference.
  • Remove the cover or any other accessories.
  • Tap-tap your phone firmly several times to eject any remaining water from the charging port.
  •  Put your phone inside a sock and slowly blow cool air into it for about three hours.
  • Your phone is dry and good to go.

Related: Emergency Override iPhone Charging – What is It? How To Use It?

Getting Water Out of the Charging Port By Gently Tapping Your iPhone

Your phone may have sucked in moisture from rain, exposure, or sweat. Then, when you connect an accessory or lighting cable to your iPhone, you get a liquid-detection alert. That will mean water in your iPhone charging port, the lighting, or the accessory cable. 

Here are the steps you have to take.

  • Unplug any accessories or cables and keep them unplugged until the phone is dry.
  • Turn your iPhone lighting connector face down, then tap-tap gently against your palm.
  • Leave your iPhone in a dry airy area.
  • Check that the alert is no longer there before you charge the iPhone.
  • After at least a day, try charging or connecting a lighting cable again.
  • Your iPhone should be completely dry after 24 hours in an area with good airflow.

How Can You Get Water Out of Your Charging Port Without Rice

Getting water into your phone’s charging port is never intentional. Nevertheless, when this situation comes into play, you must quickly do something. You may not always have a jar of rice or towels to dry it quickly.

 Here are other steps to get water from your charging port without rice. 

  • Quickly disconnect any connections and power off your phone to prevent short-circuiting.
  • If the battery is removable, quickly remove it. 
  • Then, hold your phone upright with the charge port opening facing downwards.
  • Shake your phone gently from side to side.
  •  Gravity will stop the water from going further inside and help drain the water.

How to Dry Out a Charging Port in the Sun

Heat and sun enhance evaporation. So, if your phone has a wet charging port problem, enlist the help of fresh air and sunlight to dry the water content off for you.

Dry out a charging port in the sun by following these steps: 

  • Disconnect the phone from charging or connections
  • Switch your phone off
  • Take your phone out to a place with enough sunlight and air
  • Don’t leave it too long in the sun, or it will cause damage to the screen, battery, and other internal components.  

How Can You Get Water Out of a Phone Charger Port Using a Dryer or a Vacuum Cleaner?

When your phone charger pot gets wet, you must quickly get the water out before your phone gets spoiled. Follow these DIY steps to dry the water from your phone charger port using your hair dryer:

  • Take your hair dryer and turn it to the ‘Cool’ setting
  • Blow at a slow speed toward the phone.
  • Do not use your dryer if it does not have the ‘Cool’ option, as heat will damage your phone components.

To dry water from your charger port using a vacuum cleaner:

  • Attach the hose to the vacuum cleaner
  • Attach the vacuum cleaner hose to your charger port
  • Turn it on and wait for it to suck out the water from the charging port
  • Control the suction power so that it doesn’t destabilize the phone components.

How Do You Get Water Out of Charging Port iPhone 11, 12, 13, 14 Using Silica Gel?

Like rice, silica gel absorbs a large amount of moisture. Thus, the silica gel will help dry out your damp iPhone. Here are the steps you will need to take.

  • Place your iPhone 11, 12, 13, 14, or the latest model in a tight-fitting bowl with silica gel bags. 
  • Cover the bowl with a lid.
  • The silica gel bags will dry out your iPhone.
  • Give it three days at its worst.

What Not to Do with Your iPhone if it Gets Water in the Charging Port

  • Do not panic and do anything if your iPhone gets wet.
  • Try not to put paper towels or cotton swabs into the lighting connector. 
  • Drying your iPhone using compressed air or external heat isn’t very good.
  • Do not put your phone where particles can get inside the charging port.
  • Do not let your iPhone sit while it’s wet, as this could lead to corrosion.

How to Get Water Out of a Charging Port FAQs

1. Do you know how to get water from the charger port android?

Do not panic. Check your android phone’s IP rating. The higher the IP rating, the better your phone’s protection from water and dust particles.

Tap your android phone gently and let the excess water drip. Then use a soft cloth to wipe out the water from the charger port and leave it for a few hours to dry.

2. Can you override the ‘No charging’ indicator and charge your wet phone? 

Due to an emergency, you may have to charge your iPhone when it’s wet. Connect your iPhone to the lighting or accessory cable and override the liquid detection alert.

3. Can vibration get water out of the phone charging port?

You can vibrate your phone to get water from the charging port. First, unplug your phone and clean it with a towel or cloth. Then shake to vibrate your phone up to ten times with the port facing downwards. Fan it or leave it in a well-ventilated area to dry.

4. Do you know how to get water from the charging port in Samsung?

 Should your Samsung device display a water drop icon, that will mean your device has taken in water. To get the water out, completely power off your device and leave it to dry. Also, clean your USB cache and also leave it to dry.

Sharing is caring!

You may also like